World Shakuhachi Discussion / Go to Live Shakuhachi Chat
You are not logged in.
Hi Everyone
Iam new to the forum and have been making shakuhachi for about 5 years now. I recently made a 2.0 from a thin piece of medake
everything is good about the instrument except the meri notes are difficult particularly tsu meri
this is the first time I have encountered this problem
can anyone shed some light?
Dave
Offline
DaveDew wrote:
Hi Everyone
Iam new to the forum and have been making shakuhachi for about 5 years now. I recently made a 2.0 from a thin piece of medake
everything is good about the instrument except the meri notes are difficult particularly tsu meri
this is the first time I have encountered this problem
can anyone shed some light?
Dave
In general, the bigger the bore, the easier the meri's (assuming a pretty typical aspect ratio), and vise versa, especially when you get a blowing end bore diameter under 2 cm.
Offline
Thanks Edosan
I have also read that under cutting the finger holes can Improve the meri notes. Has anyone experimented with this
approach? keeping in mind that this also raises the pitch of the basic note
Dave
Offline
Hi, Dave...
There is some very good reading about undercutting, pro's & con's, tone, etc. in quite a few threads here. Two good ones are located at:
http://www.shakuhachiforum.com/viewtopic.php?id=2929
http://www.shakuhachiforum.com/viewtopic.php?id=2967
Much more will surface through a forum search for "undercutting", as well...
Enjoy!
Offline
Thanks Derek
I'll keep looking
Dave
Offline